Hallo AS400 Gemeinde,

das leidige Thema mit der Fehlermeldung CPF9E7F - möchte ich nochmal aufgreifen:
Die Meldung CPF9E7F nervt nach Neu-Installationen (bei Systemen ohne HMC) .
Temporär Abschalten ist keine Dauerlösung mit der u. a. Option:

CPF9E7F - Nutzungsbeschränkung 4 Prozessoren überschritten.
Temporäre Lösung:
CALL QSYS/QLZACBUA PARM('INFO') – zeigt min. 1 Prozessor, genutzt 4 Prozessoren an
CALL QSYS/QLZACBUA PARM('1') – stellt die Nutzung temporär auf 1 Prozessor ein bis zum nächsten Neustart
CALL QSYS/QLZACBUA PARM('INFO') – nochmal zur Kontrolle, wie oben, jetzt wird aber nur 1 Prozessor als genutzt angezeigt.

Wie weiter unten beschrieben soll die Anzahl der aktiven Cores von 4 auf 1 via ASMI-Zugang reduziert werden. Dazu ist ein CELOGIN erforderlich, rückt IBM wahrscheinlich nur an IBM-Techniker raus.

Ich suche einen Lösung die kurz und knapp zu realisieren ist und keinen großen Aufwand erfordert, gibt es einen Tipp?

CPF9E7F - IBM Usage Limit Exceeded on Stand-Alone System
Technote (troubleshooting)

Problem(Abstract)
Message CPF9E7F - IBM usage limit exceeded message is being received on a stand-alone system after the license key for 57xxSS1 Feature Code 5051 was applied successfully.
Symptom
After applying license key 57xxSS1 Feature Code 5051 successfully on the stand-alone system, error message CPF9E7F was received in QSYSOPR message queue.

Resolving the problem
On stand-alone systems, there are two options to limit the processor usage in order to comply with the processor usage limit per the 57xxSS1 FC 5051 license key.
• Option 1: Deconfigure the processors through ASM using the Field Core Override

Note: How to access the ASMI on a stand-alone system:
http://publib.boulder.ibm.com/infoce...by/browser.htm

From ASMI, you should perform the following:

1. Verify the system is powered down and in standby mode (flashing green power light). If the system is still powered on, power down partition with restart *NO.
2. Access ASMI with celogin ID and password. (Contact Software Support for celogin password.)
3. Expand System Configuration > Hardware Deconfiguration.
4. Select Field Core Override and change to the number of processors to equal the usage limit on the license.

Viele Grüße
Mida